HW113

Owned by Sung Lee (Deactivated)
Last updated: Oct 31, 2022
2 min read



Activate the touch panel

  1. Press the touch panel to wake it up (Fig 1,1).

Note: The touch panel may be black when you first walk into the room. Press anywhere on the screen once to display the welcome screen (Fig 1,1)


.


Select your source (If you planning to use webcam)

The Home screen provides a list of sources that are available in the classroom. These sources will vary depending on the room type. In this image, you will see that you may choose to display the following source

  • Room PC (The computer is located above cabinet)
  • Air Media (wireless screen sharing)


  1. Press your desired source
  2. For this example the Room PC has been selected.

For Video Conferencing, select the Video Conference Preset


Select your destination

  1. Press your destination

Note: If you select a traditional projector the screen will lower automatically and the projector will turn on when you press Go. The screen will also rise automatically when you turn the projector off. 


Blank the projector

The Projector Video Mute button allows you to temporarily blank the projector screen.

  1. Press the Projector Video Mute button at the bottom right of the touch panel. The projector will stop projecting the selected source and the button will flash pale blue (Fig 4).
  2. Press the Projector Video Mute button again to resume displaying the projector (Fig 4).


Adjust the volume

When you select a source that can play audio (Room PC or a laptop, etc.), when you press a projector, the Room Speakers  will automatically be selected.

Note: Check the volume on the computer and on the video presented to ensure they are not muted.